Polymer processes and polymer applications require polymer transfer pumps which will constantly and reliably feed oligomers and prepolymers through the system. The liquid polymer pump design is highly suitable for low viscosity. Thanks to thermorex® TRP and TRO, reactors no longer have to be pressurized. The good efficiency and long service life increase the efficiency of your production plant with polymer transfer pumps from MAAG.
Configure your own product according to your requirements and needs. If you are unsure of the configuration, provide us in the notes the necessary information about the existing sensor or product, even a competitor. We will be happy to help you find an alternative MAAG products. If your request is urgent, let us know. We will do our best to help you resolve this situation to your satisfaction as quickly as possible. If we have all the information, we are able to offer a model with minor differences.
If you need more information do not hesitate to contact us.
| Rotational speed [U/Min] | max. 100 | |
| Torque [Nm] | max. 600000 | |
| Differential pressure [bar] | max. 320 | |
| Viscosity [MPas] | max. 20000 | |
| Temperature [°C] | 350 | |
| Throughput rate [kg/h] | max. 55 | |
| Pump size | 100 – 380 | |
| Output [l/Min] | max. 900 | |
| Housing | Alloy- / Carbon Steel - other materials on request | |
| Gear shafts | Nitrided steel / tool steel | |
| Bearing | Tool steel / ALBr / special materials | |
| Shaft seal |
Viscoseal, vispac®, double mechanical seal with barrier system |
|
| Connections | ANSI or DIN standards | |
| Pump heating | Heated with oil: max. 350°C, at max. 15 bar with saturated or superheated steam: max. 40 bar |
|
| Installation | The thermorex® gear pump can be flanged into the line, or also directly to mixer, kneader or extruder | |
| Suction side | thermorex⁶ TR Pump with one seal (on drive side) Inlet pressure: up to 15 bar thermorex⁶ TB Pump with extended shaft (2 seals required) Inlet pressure: up to 100 bar thermorex⁶ TP Prepolymer transfer pump with one seal (drive side). Inlet pressure: up to 15 bar*depending on the sealing type |
|
Cellulose acetate
|
|
|
Elastomers
|
|
|
Epoxy resin
|
|
| Phenolic resin | |
| Polyacrylicnitrile | |
| Polyamide | |
| Polycarbonate | |
| Polybutylene Teraphthalate | |
| Polymethylmethacrylate | |
| Polypropylene | |
| Polystyrene (incl. ABS, EPS) | |
| Polysulphone | |
| Silicone | |
| SBR Latex | |
| And other | |
| Paints and varnishes | |
| Waxes and paraffins | |
| Mineral oils and fats | |
| Fuels | |
| Petrochemical products | |
| Lube oil |